Precautions for oil burner operation
Nowadays, oil burners are widely used in industrial production. Because of this, the fuel oil burner has received a certain degree of popularity and attention. Let's learn about the precautions when the fuel oil burner works.
1. The motor shall be damp-proof to avoid using in humid environment. When installing the burner, it should be balanced, horizontal or vertical to avoid tilting. Regularly check whether the connection between the burner and each component is firm and loose, and whether the position changes.
2. The ambient temperature of the burner shall not exceed 70 ℃, otherwise, cooling and thermal insulation measures shall be taken. When it is used in low temperature areas, appropriate thermal insulation measures shall be taken to prevent freezing and blocking of the oil circuit. At the same time, the control circuit of the burner shall not be affected by moisture or high temperature. Please turn off the burner when cleaning the chimney.
3. When the direct operation of the burner is inconvenient, the external control switch and electrical protection device shall be used. When the burner is started, strictly prevent the sudden flame from hurting people and damaging objects.
4. When connecting the peripheral circuit to realize the automatic control of boiler temperature, pressure, water level, etc., connect according to the control system wiring diagram.
5. The size of damper shall match the nozzle specification. When using the burner, due to the inconsistency between the boiler equipped and the boiler that the burner is adjusted for trial use at the time of delivery, it is usually necessary to properly adjust the damper, and sometimes it is necessary to replace the nozzle with appropriate specification and injection angle.
6. The oil suction pipe shall not be close to the bottom of the oil tank, and the distance shall be 80-120mm. Before oil injection, the burner shall be shut down, the fuel oil shall be filtered and injected into the oil tank, and the oil can be restarted after 20 minutes. The oil circuit system shall be free of oil and gas leakage. Before starting the burner, check whether the fuel tank is sufficient.