Introduction to Daily Maintenance Work Instructions for Fully Premixed Low Nitrogen Burners
The daily maintenance of the fully premixed surface burner is very important. When using a burner, the maintenance of the burner is related to its service life. Regular maintenance can extend the lifespan of the burner. Today, I will take you to learn about gas combustion. How to maintain the machine on a daily basis.
Main gas source - For burners using natural gas as fuel, please check the main gas source control valve to ensure that the circuit is in good condition. If there is an induction circuit, please check if it is damaged.
Filter - If a "y" type filter is installed before the control valve, it must be cleaned. Full premixed surface burner
Control regulating valve - Check the control regulating valve on the gas burner to see if the adjusting bolt is easy to adjust. Ensure that all sockets and screens are not blocked.
Full premixed surface burner - Check the gas pipeline group to confirm if the manual switch is sensitive and the valve handle is installed. Check if the barometer is working properly. Accurate pressure display is crucial when adjusting the gas burner. Rotate the low-voltage and high-voltage switches to confirm their operating conditions. The connection of the air valve needs to be cleaned and lubricated. If the connection is too sticky or rough, it needs to be replaced with suitable accessories. If the burner is equipped with detachable pipes, it should also be cleaned.
The fully premixed surface burner is an important component of asphalt mixing equipment. The combustion effect of the burner is related to the dryness of the aggregates, fuel consumption rate, dust collection bags, and the safety of equipment and personnel. Let's take a look at the working process and troubleshooting of the burner together.
The main fuels for fully premixed surface burners are natural gas, liquefied petroleum gas, urban gas, and other combustible gases. These fuels are flammable and explosive dangerous gases. Attention should be paid to safety during use and storage, otherwise major safety accidents may occur.